The car was hit on the right side It can be seen that the two doors on the right are basically scrapped Follow my camera to see how it comes back to life first remove the door the front door won't open Can only be opened with a crowbar lift the door up This will remove it Extensive interior damage, all airbags deployed remove the seat pull out shape inside with a hammer Remove the skin sheet metal cut notch pull this part top inside hammering Remove the original car solder joints Cut the damaged position Cutting the inner edge beam It is easier to pull Pull this position too cut off new accessories What do you think of my doing? Please leave me your review! ! punch a hole here Fasten it with two screws put new doors install back door The gap is ok Back cover gap is a bit big pull back here that's good Do some anti-rust treatment on the place where the paint is peeled off Install the outer sheet metal welding fixed welded on top Officially install the doors adjust this position The alignment position is fixed by electric welding Weld all interfaces Anti-rust treatment inside seal the gap Check the gap after welding Brush epoxy primer Paint the inside too car door sealant The painting step is omitted Baking paint room Replace the seat install the door door handle install glass Install rearview mirror rear door At this point, the maintenance is over, thank you for watching If you like, please subscribe to our channel, thank you for your support